Read-only SAS cable?

Pradeep

Pradeep

0
Joined
Jan 21, 2002
Messages
3,845
Location
Runny glass
Have you guys ever heard of a read only (forensic) SAS cable?

My initial thoughts are that such a thing doesn't exist as of yet.

TIA, Pradeep.
 
I don't see how it can occur.

A SAS cable is basicly a set of transmit/receive serial cables. All the actual data is encoded inside SCSI commands to be intrepreted by the two controllers. It would be in the controllers/Drive/OS layers not the physical cable where such a command could be given and enforced
 
Left-handed spanner? Ghost has a forensic mode, but I don't see how a cable could. It's just wires that transmit electricity.
 
Apparently one of the guys at work could make one by breaking off a pin or connector with the ole PATA drives. Can't get away with that during serial ops.
 
I thought some SCSI hard drives came with a WORM mode that could be enabled via jumper?
 
Handruin said:
I thought some SCSI hard drives came with a WORM mode that could be enabled via jumper?
Click to expand...

The SCSI communication standard has a write only sense code that can be set via software per device or HW, commonly set via a jumper but can be firmware-wired into the device controller, but that is still not at the physical cable level.
 
I can't see how such a thing would be possible with serial communications. Which wire is "send"? Which "receive"? Unless the cable had a full-blown computer connected to it, that prevented any writes from going back to the drive...
 
P5-133XL said:
The SCSI communication standard has a write only sense code that can be set via software per device or HW, commonly set via a jumper but can be firmware-wired into the device controller, but that is still not at the physical cable level.
Click to expand...

I kinda thought so, but I guess my point was why deal with this in the cable, when you can do it on the drive?
 
You must log in or register to reply here.
Back
Top