P4 2.4'C' , 1GB OCZ DDR400 , Asus GF4/4800SE VIVO

[Jake the Dog]

All this gear has been well cared for and is as new.

P4 2.4C. does 3.2 @ 1.55v. Can't tell how high this CPU clocks as I've never pushed it any harder. Core temps have never been over 40C. Comes boxed, with unused Intel HSF.
- Purchased one month ago (17/6/03)
- Reason for sale: upgraded to faster CPU
- Reserve: AU$260
- Current highest bid:

1GB (2 x 512MB) OCZ Basic Series DDR400 (http://members.optusnet.com.au/v8gent/forumposts/OCZPC3200Black.jpg). Black heat spreaders. SPD timings are 2.5-4-4 however I have successfully run this RAM at 2-3-3-6/210MHz on my Asus P4P800 and 2-3-3-6/200MHz on my Soltek nForce2 mobo. at 210Mhz on the nForce2 I had to change timings to 2-3-3-7. Highest speed tested was 217MHz at 2.5-3-4-7 timings on nForce2 board. May go higher but the Athlon wouldn't. Always run in dual channel setup. Note: RAM has never had more than 2.65V through it, and only then it was for short time, when benchmarking.
- Purchased 3.5 months ago (06/04/03)
- Reason for sale: upgraded to faster RAM
- Reserve: AU$300
- Current highest bid:

Asus V9480 VTD G4 Ti4800SE-8X 128Mo ViVo (http://www.asus.com/products/vga/v9480tvd/overview.htm). Never used.
- Purchased 3 days ago (14/7/03)
- Reason for sale: Impulse purchase. Decided to go with a 9800Pro instead so now not needed.
- Reserve: AU$200
- Current highest bid:

Buyer pays postage. Please post all questions, bids, comments in this thread. Thanks and happy bidding!

[honold]

what cpu did you go to?

i'm very happy with my 2.4@3.1

[Jake the Dog]

2.8C (as per my sig :))

[honold]

how's your ram running (multiplier, timings, voltage)?

[Jake the Dog]

I've only just got the system up and running and have set the FSB:Mem ratio to 5:4. timimgs are 2-2-2-5 @ 2.55V. I'm waiting for the Shin-Etsu thermal paste to cure before I start pushing limits. when everything is settled in properly, the plan is to up the FSB:Mem ratio to 1:1 and run this RAM at 2.5-4-4-8 @ 250MHz with 2.65-2.75V. if I'm lucky I can go higher again.

[blakerwry]

2.8C (as per my sig :))

your sig is not readable on the cosmic distortion theme...

[Jake the Dog]

thakh sofr highlighting that blakerwry, I think UI've fixed it to be readable for all themes.